Confederation Of Clubs - North Dakota Ride Free- with Honor & Liberty.  
 
ND COC SCHEDULED MEETINGS ND CLUB CALENDAR EVENT SCHEDULE

Confederation of Clubs Nationwide

Find a Confederation of Clubs in Your State

FUSION CENTERS
Find A Fusion Center Near You

 

 

ATTENTION: The COC of North Dakota is not in the business of starting or validating "New MCs". If you are interested in starting a new MC you should contact your local MC and they can give you insight into the proper procedures. Please DO NOT contact COC of North Dakota board members. If you have serious intentions, please attend a COC meeting. Thank You

Ten Simple Steps to Winterize Your Motorcycle
 
1) Surface Prep
Washing your bike when nobody will see it for a few months anyway can be a drag, but
giving your bike a thorough cleaning before storage is important; letting bug guts or water
spots sit on your paint can corrode the finish permanently. Wash your bike and dry it
completely to get all the moisture off the surfaces (an electric leaf blower is a great way to
get all the nooks and crannies really dry.)

Add a coat of wax, which will act as a barrier against moisture and rust. Finally, spray
exposed metal surface with WD-40 to displace all moisture (fun fact: the WD in "WD-40"
stands for water displacement) and to give them a protective coating against corrosion.
 
2) Change Oil and Filter
Change your oil and filter. It's better for your lubrication system to have fresh oil sitting in it
for several months than to have used, broken down oil in it, not to mention the last thing
you'll want to do when riding season begins is change the oil before you can go ride. Using a
winter weight oil like 5W30 can help it start up easier come spring time as well.
If you're going to be storing your bike for a long time (4-6 months or more) you will want to
protect your engine's internals against moisture by coating them lightly with oil. You may
not be able to see it with your naked eye, but the cold winter air is perfect for moisture to
gather in your engine and cause rust to form on your pistons and cylinder walls.
In order to do this, remove the spark plugs and put a little squirt (about a tablespoon) of
engine oil into the holes, then turn your engine over a few times to coat the cylinder walls by
spinning the rear wheel with the bike in gear. Once everything is coated, replace the spark
plugs.
 
3) Lube Moving Parts
Keeping moving parts lubed during the winter will help keep moisture from building up on
them and causing any rusting or binding. Any part of your motorcycle that needs to be lubed
at any point should be lubed again before storage. Some parts to check are: chain drive,
cables, controls, fork surfaces, and any other pivot points.
 

 
4) Prep Fuel System
Gas tanks have a tendency to rust when not in use, and untreated pump gas breaks down and
becomes gummy over time. To prevent rusting and make sure your fuel is ready to run after
a few months in storage, you'll want to fill your tank completely with fuel treated with a
product like Sta-Bil Fuel Stabilizer.
On your last ride of the season, stop in at the gas station nearest to where you will be storing
your bike and add the proper amount of fuel stabilizer, then top off the tank. A full tank will
keep moisture from building up on the tank walls, and adding the stabilizer before the short
ride home will help mix the gas and stabilizer together and run it through your fuel system
before storage.
Note: Another method that some advocate is to drain the tank and fuel system completely.
This is more troublesome to do, and requires that you treat the inside of the tank with
fogging oil to prevent rusting. This method may be preferred for very long-term storage (6
months or more), but for winter storage, a full tank of treated fuel is easier and completely
safe to do for both carbureted and fuel-injected bikes.
 
5) Safeguard Battery
Batteries have a tendency to self-discharge when sitting over time, especially when they
remain hooked up to the bike. The easiest way to combat this is to hook up a battery tender
like the Battery Tender Super Smart Junior which uses smart technology to monitor the

charge and keep the battery topped off without overcharging. Normally you should pull the
battery from the bike for storage, but with a smart tender you can also connect the tender
with the battery left in the bike. Before doing this, make sure the electrodes are clean and
corrosion free; if necessary, clean them off and give them a light coating of grease.
 
6) Protect Tires
If your tires are left to sit in the same position all winter long, they could develop flat spots.
Keeping the tires off of the ground will prevent this, so if you have Motorcycle Stands, put the
bike up on them for storage. If you don't have stands, try to get at least the rear tire off the
ground, or you can rotate your tires by rolling your motorcycle slightly every few weeks. If
you need to leave your tires down on concrete, put a piece of carpet or plywood under them
to keep any moisture from seeping into them.
 
 
7) Check Coolant/Anti-freeze (If Applicable)
If you'll be storing your bike somewhere that gets below freezing, make sure you have
adequate levels of anti-freeze in your coolant system. This is very important; if you run
straight water in your coolant system and it freezes, you could come back to a cracked head
in the spring!
 
8) Plug Out Pests
Mice and other rodents are notorious for hiding from the cold inside exhaust pipes and
making homes out of air filters. If order to avoid any furry surprises when it's time to ride
again, plug up your pipes with an exhaust plug like the BikeMaster Rubber Muffler Plug. You
can also simply stuff your air intake and the ends of your exhaust with some plastic bags -
but do use bright colored bags or tie something to them so you don't forget take them out
when you fire up the bike!
 
9) Keep it Covered
With your motorcycle fully prepped for winter, invest in a proper motorcycle cover. A
quality motorcycle cover will not only keep dust off the bike, but will keep the moisture out
so it doesn't get trapped underneath it, and create corrosion or rust. If you're storing it
outside, be sure to get a cover with tie downs to prevent it from blowing loose in wind. If
you're storing it inside you're in much better shape, but you should still use a cover to
prevent dust from building up on it.
 
10) Theft Protection
If you're storing your bike outside, bear in mind that being parked unattended for months at
a time makes it an easy target for theft. In addition to protecting your bike from weather,
using a cover will conceal it from view, and securing it with a heavy lock and chain can give
you some peace of mind. If youll be storing your bike anywhere it can be accessed by others,
read our guide on How To Keep Your Motorcycle From Getting Stolen, and consider investing
in some security measures.
 

With your bike fully prepared for a few months of hibernation, you'll find that the winter is
the perfect time to get done any maintenance or upgrade projects that you've had on your
mind.

Life, Liberty and the pursuit of Happiness.
That to secure these rights, Governments are instituted among Men, deriving their just powers from the consent of the governed, — That whenever any Form of Government becomes destructive of these ends, it is the Right of the People to alter or to abolish it, and to institute new Government, laying its foundation on such principles and organizing its powers in such form, as to them shall seem most likely to effect their Safety and Happiness.
When a long train of abuses and force without legal authority, pursuing invariably the same Object demonstrate clearly a design to reduce them Under absolute Despotism, it is their right, it is their duty, to throw off such Government, and to provide new Guards for

their future security.

~Thomas Jefferson

John Adams

Benjamin Franklin

Roger Sherman

Robert Locke